Note
Please report issues with the manual on the GitHub page.
4.5.2.1. CBLinput¶
-
EntrainmentType
¶
Requirement: Required
Description: Determines entrainment scheme. See Cleugh and Grimmond 2000 [16] for details.
Configuration: Value Comments 1 Tennekes and Driedonks (1981) - Recommended in this version. 2 McNaughton and Springs (1986) 3 Rayner and Watson (1991) 4 Tennekes (1973)
-
QH_Choice
¶
Requirement: Required
Description: Determines QH used for CBL model.
Configuration: Value Comments 1 QH modelled by SUEWS 2 QH modelled by LUMPS 3 Observed QH values are used from the meteorological input file
-
InitialData_use
¶
Requirement: Required
Description: Determines initial values (see CBL_initial_data.txt)
Configuration: Value Comments 0 All initial values are calculated. Not available in this version. 1 Take zi0, gamt_Km and gamq_gkgm from input data file. Theta+_K, q+_gkg, Theta_K and q_gkg are calculated using Temp_C, avrh and Pres_kPa in meteorological input file. 2 Take all initial values from input data file (see CBL_Initial_data.txt).
-
Sondeflag
¶
Requirement: Required
Description: to fill
Configuration: Value Comments 0 Does not read radiosonde vertical profile data - Recommended in this version. 1 Reads radiosonde vertical profile data
-
CBLday(id)
¶
Requirement: Required Description: Set CBLday(id) = 1 If CBL model is set to run for DOY 175–177, CBLday(175) = 1, CBLday(176) = 1, CBLday(177) = 1 Configuration: to fill
-
CO2_included
¶
Requirement: Required Description: Set to zero in current version Configuration: to fill
-
FileSonde(id)
¶
Requirement: Required Description: If Sondeflag=1, write the file name including the path from site directory e.g. FileSonde(id)= ‘CBLinputfilesXXX.txt’, XXX is an arbitrary name. Configuration: to fill
-
InitialDataFileName
¶
Requirement: Required Description: If InitialData_use ≥ 1, write the file name including the path from site directory e.g. InitialDataFileName=’CBLinputfilesCBL_initial_data.txt’ Configuration: to fill
-
Wsb
¶
Requirement: Required Description: Subsidence velocity (m s-1 ) in eq. 1 and 2 of Onomura et al. (2015) [17] . (-0.01 m s-1 Recommended in this version.) Configuration: to fill